IO_GETEVENTS

Section: Linux Programmer's Manual (2)
Updated: 2013-04-08
Index Return to Main Contents
 

NAME

io_getevents - read asynchronous I/O events from the completion queue  

SYNOPSIS

#include <linux/aio_abi.h>         /* Defines needed types */
#include <linux/time.h>            /* Defines 'struct timespec' */

int io_getevents(aio_context_t ctx_id, long min_nr, long nr,
                 struct io_event *events, struct timespec *timeout);

Note: There is no glibc wrapper for this system call; see NOTES.  

DESCRIPTION

The io_getevents() system call attempts to read at least min_nr events and up to nr events from the completion queue of the AIO context specified by ctx_id. The timeout argument specifies the amount of time to wait for events, where a NULL timeout waits until at least min_nr events have been seen. Note that timeout is relative.  

RETURN VALUE

On success, io_getevents() returns the number of events read: 0 if no events are available, or less than min_nr if the timeout has elapsed. For the failure return, see NOTES.  

ERRORS

EFAULT
Either events or timeout is an invalid pointer.
EINVAL
ctx_id is invalid. min_nr is out of range or nr is out of range.
EINTR
Interrupted by a signal handler; see signal(7).
ENOSYS
io_getevents() is not implemented on this architecture.
 

VERSIONS

The asynchronous I/O system calls first appeared in Linux 2.5.  

CONFORMING TO

io_getevents() is Linux-specific and should not be used in programs that are intended to be portable.  

NOTES

Glibc does not provide a wrapper function for this system call. You could invoke it using syscall(2). But instead, you probably want to use the io_getevents() wrapper function provided by libaio.

Note that the libaio wrapper function uses a different type (io_context_t) for the ctx_id argument. Note also that the libaio wrapper does not follow the usual C library conventions for indicating errors: on error it returns a negated error number (the negative of one of the values listed in ERRORS). If the system call is invoked via syscall(2), then the return value follows the usual conventions for indicating an error: -1, with errno set to a (positive) value that indicates the error.  

BUGS

An invalid ctx_id may cause a segmentation fault instead of generating the error EINVAL.  

SEE ALSO

io_cancel(2), io_destroy(2), io_setup(2), io_submit(2), aio(7), time(7)


 

Index

NAME
SYNOPSIS
DESCRIPTION
RETURN VALUE
ERRORS
VERSIONS
CONFORMING TO
NOTES
BUGS
SEE ALSO

This document was created by man2html, using the manual pages.
Time: 02:54:48 GMT, September 18, 2014